Midway CART Fury Championship Racing, Руководство по эксплуатации

Страница: 13 / 104

C.A.R.T. FURY 7
C
HAPTER
1 O
PERATION
6. Roll the pedestal section near the cabinet, align the opening in the pedestal with the ends of the rails.
Slide the pedestal forward onto extended mounting rails leaving enough space to attach the wiring har-
ness. Mate each cable connector and press firmly to seat the contacts. Ensure no wires are pinched
during pedestal attachment. Attach pedestal assembly using 1/4-20 tamper resistant screws and large
flat washers provided in spare parts. A T27 wrench is included with the spare parts to tighten these
screws firmly. Tighten the hex head bolts after the tamper resistant screws have been tightened.
7. Lower and adjust each leg leveler until the pedestal section is stable and level. Adjust the levelers until
the bottoms of all pieces are flush and parallel with each other. Inspect for binding or pinched wires.
Insert and firmly tighten the remaining fasteners to attach the two pieces together as a single unit.
REAR DOOR HASP INSTALLATION
8. An extra padlock may be installed to secure the rear door. A hasp is located in the spare parts bag.
Remove the two lock bracket nuts from inside the cabinet, above the rear door opening. Slide the hasp
bracket onto the bolts so that it protrudes from the hole in back of the cabinet, then reinstall nuts.
9. Modify the lock plate at the top of the rear door. Remove the bolts and nuts from the lock plate, then
rotate the plate so that the slot will be above the door. Reinstall the bolts and nuts and tighten firmly.
10. Reinstall the rear door onto the cabinet and close it. Lock the rear door and remove the key. If
required, install the extra padlock through the hasp at this time. Install the screws at the top and sides
of the rear door and tighten snugly. Leave the remaining doors open at this time.
LINE CORD INSTALLATION