Midway CART Fury Championship Racing, Руководство по эксплуатации

Страница: 50 / 104

6 M
IDWAY
A
MUSEMENT
G
AMES
, LLC
C
HAPTER
3 S
ERVICE
To service Viewing Glass…
Refer to Viewing Glass and Bezel Service illustration.
• Switch off the power to the game machine and unplug the AC line cord.
• Remove the dashboard. Refer to service instructions for Dashboard.
• Gently slide the viewing glass up and lift it out of the cabinet. Set the viewing glass aside.
• Perform the desired repair or equipment replacement.
• Clean both the bezel and the viewing glass before reinstallation.
To service Monitor Bezel…
Refer to Viewing Glass and Bezel Service illustration.
• Switch off the power to the game machine and unplug the AC line cord.
• Remove the dashboard. Refer to service instructions for Dashboard.
• Gently slide the viewing glass up and lift it out of the cabinet. Set the viewing glass aside.
• Grasp the monitor bezel at the bottom and lift it out of the cabinet.
• Perform the desired repair or equipment replacement.
• Clean both the bezel and the viewing glass before reinstallation.
To service the Monitor (CRT)…
We recommend that you read the WARNINGS thoroughly before beginning this procedure.
• Switch off the power to the game machine and unplug the AC line cord.
• Remove the Dashboard, Viewing Glass and Monitor Bezel. Refer to service instructions for the Dash-
board, Viewing Glass and Monitor Bezel.
• Open the rear cabinet door and disconnect the monitor from the wiring harness and ground wires.
• Remove 4 nuts securing the monitor mounting flanges to the mounting panel.
• Pull the monitor carefully from the cabinet and set aside.
• Perform the desired repair or equipment replacement.
To service the Dashboard…
Refer to Dashboard Service illustration.
• Switch off the power to the game machine and unplug the AC line cord.
• Open the rear cabinet door.
• Label and disconnect all dash wiring, including the ground strap.
• Remove the four screws used to fasten the Dashboard to the cabinet.
• Firmly grab the dash and pull it straight out. NOTE: The Dashboard is heavy, with most of the weight
concentrated in the center near the Steering Mechanism.
• Perform the desired repair or equipment replacement.
• To reinstall, line-up the holes on either side of the Dashboard and push straight back.
• Check for pinched wires, and then reconnect dash wiring and ground strap.
• Fasten in place with the screws provided.
CAUTION
The video monitor is heavy, with most of the weight toward the front of the assembly.
Be sure it is firmly supported as it is moved from the cabinet.
WARNING
The monitor does not require isolation from the AC line voltage in normal operation.
When operating outside the cabinet or servicing the monitor on a test bench, ISOLATE
THE MONITOR FROM LINE VOLTAGE WITH AN ISOLATION TRANSFORMER.