Midway CART Fury Championship Racing, Руководство по эксплуатации

Страница: 54 / 104

10 M
IDWAY
A
MUSEMENT
G
AMES
, LLC
C
HAPTER
3 S
ERVICE
S
TEERING
W
HEEL
H
OOP
S
ERVICE
To service Boost Buttons on the Steering Wheel Hoop…
Refer to the Steering Wheel Hoop Service illustration.
• Switch off the power to the game machine and unplug the AC line cord.
• Remove the screws used to fasten the wheel hoop cap to the steering wheel. Lift of the hoop cap off and
set it aside with the hardware for reuse later.
• Lift out the steering wheel spacers.
• Gently pull the steering wheel forward enough to expose the boost button cable connector.
• Unplug the boost button cable. Remove the steering wheel completely from the dashboard.
• Turn the steering wheel over to observe the rear side of the wheel hoop. Remove the tamper resistant
screws used to fasten the rear cover to the steering wheel hoop. Lift the cover off and set aside with the
hardware for reuse later.
• Use a desoldering tool coupled with a soldering iron to remove the solder used to attach the cable wires
to the button’s switch. NOTE: Use caution when performing this step to avoid becoming burned by lique-
fied solder and /or to avoid melting plastic parts.
• Allow the area surrounding the switch and button to cool properly before proceeding.
• Unscrew the nut on the button. Lift the button out of the steering wheel hoop.
• Perform the desired repair or equipment replacement.
• Be sure to solder the cable wires to the button’s switch when reinstalling a button(s).
• Reinstall and fasten all items in place with the screws provided.
To service Lower Cabinet Speaker…
This speaker is located just above the pedal assembly.
• Switch off the power to the game machine and unplug the AC line cord.
• Unlock and remove the rear cabinet door.
• Label and disconnect wiring, including the ground strap, to Board assemblies attached to the electronics
shelf.
• Remove the screws used to fasten the electronics shelf inside the cabinet, then remove the shelf and set
it aside.
• Locate the speaker. Remove the nuts on the mounting screws before removing the speaker from the
enclosure.
• Perform the desired repair or equipment replacement.
• Carefully reseat the seals upon completing any task in the speaker enclosure.
• Reconnect the wires, including ground. Refer to the Cabinet Wiring Diagram for correct speaker polarity.