Midtronics MDX-650 MILITARY, Инструкция по эксплуатации

Страница: 9 / 20

•
9
•
Preparations Before the Test
Before connecting the tester, clean the battery posts or side terminals with
a wire brush and a mixture of baking soda and water. When testing side-
post batteries, install and tighten lead terminal adapters. A set of adapters is
included with the tester.
IMPORTANT: Do not test at steel bolts. Failure to install terminal adapters or
installing terminal adapters that are worn or dirty may result in inac-
curate test results. To avoid damage, never use a wrench to tighten the
adapters more than 1/4 turn.
If you are testing in the vehicle, make sure all accessory loads are off, the key is
not in the ignition, and the doors are closed.
Connecting the Tester
t $POOFDUUIFSFEDMBNQUPUIFQPTJUJWF UFSNJOBMBOEUIFCMBDLDMBNQUP
the negative (–) terminal.
t 'PS B QSPQFS DPOOFDUJPO SPDL UIF DMBNQT CBDL BOE GPSUI5IF UFTUFS SF -
quires that both sides of each clamp be firmly connected before testing. A
QPPSDPOOFDUJPOXJMMQSPEVDFB$)&$,$0//&$5*0/PS8*((-&$-".14
message. If the message appears, clean the terminals and reconnect the
clamps.
t 5IFQSFGFSSFEUFTUQPTJUJPOJTBUUIFCBUUFSZUFSNJOBMT*GUIFCBUUFSZJTOPU
accessible, you may test at the jumper post; however, the available power
measurement may be lower than the actual value.
www.midtronics.com
MDX-650P
Battery Conductance &
System Analyzer