Midea KJRM-120H2/BMWKO-E, Руководство пользователя

Страница: 11 / 56

7
3.3 Mode Setting
In Unlock mode, Press " " button to enter the menu setting interface, Press " ▼ " and
" ▲ " buttons to select "MODE" and set a mode, and Press " " button as shown in
the above figure to access the submenu (mode setting). As shown below: three modes
available.
12/04/2019 MON 10:35A
COOL
TW TWS 9 C
7 C
12/04/2019 MON 10:35A
HEAT
TW TWS 40 C
55 C
12/04/2019 MON 10:35A
DHW
T5 T5S 40 C
60 C
ADDRESS
01#
Cycle: Cooling-->Heating-->DHW-->Cooling. Skip the mode cycle when there is no
corresponding mode. The DHW mode is divided into single pump (no need to select the
address) and multiple pumps (need to select address 00-15, and the address of the unit
without DHW function is directly skipped).
Only Tws/T5s and address can be set in cooling, heating and DHW mode. Tw/T5 can only
be displayed but not be set. DHW can only be power on/off under the MODE setting.
HP-Cooling setting range lower limit is subject to the low water outlet control setting under
SERVICE MENU. CO/FC-Cooling setting range lower limit is subject to the lowest outlet
water temperature set by antifreeze ratio under PROJECT MENU.
Note: When the setting temperature is lower than 5°C, the water-side system must
increase more than 15% of antifreeze, otherwise there will be a risk of damage to the
unit.
Press " " to save the settings after setting and back to homepage. Or press" " to
back. When there is no operation for continuous 60s, it will save the settings and back to
homepage.