Midas M32R LIVE, Руководство пользователя

Страница: 50 / 67

50
DIGITAL RACK MIXER M32R User Manual
Dual Tube Stage / Stereo Tube Stage
Tube Stage / Overdrive is a versatile effect capable of emulating a variety of
modern and classic tube amps. Available in stereo and dual-mono versions,
use Tube Stage / Overdrive to dial in warm and fuzzy sounds from subtle to
fully-saturated.
DRIVE adjusts the amount of harmonics being driven by the effect. EVEN and
ODD
adjusts the amount of even and odd harmonics.
GAIN
adjusts the output
gain of the effect. LO CUT sets the input frequency below which the source
signal will not pass through the effect. HI CUT sets the input frequency above
which the signal will not pass through the effect.
BASS GAIN/FREQ
adjusts a
low-shelving filter at the output of the effect. TREBLE GAIN/FREQ adjusts a
high-shelving filter at the effect’s output.
Dual Pitch Shifter / Stereo Pitch
Pitch sifting is often used in two different ways; one is to set the MIX control
lower and only use the
CENT
control to make a small offset in pitch between
the wet and dry tones. This results in a ‘voice doubling’ effect that thickens the
overall sound in a more subtle way. The extreme use of this effect is to turn
the
MIX
control fully-clockwise so that the full sound is affected. This way,
the signal can be shifted into other keys up to an octave above or below the
original key. When used on a voice, it results in a ‘chipmunk’ sound or a low,
‘Darth Vader’ effect.
When the
SEMI
and
CENT
push encoders are set to 12:00, the pitch is
not altered. Making adjustments by semitone will have a very pronounced
effect, whereas changes to the CENT control will be very minor. The DELAY
control creates a time difference between the wet and dry sounds. The
LO
CUT and HI CUT push encoders allows the affected signal to be band-limited.
The Dual-Pitch effect allows the left and right channels to be adjusted
independently, and allows gain compensation and panning of the two channels.
3. Rear Panel
3.1 MONITOR / CONTROL ROOM OUT
(1)
Talkback Microphone Input
Connect a talkback mic via standard XLR cable.
(2)
BAL / UNBAL Left & Right Jack Sockets
Connect a pair of studio monitors using standard ¼" cables.
3.2 AC / POWER
(1)
Power On / Off
Turn the console on and off with the On / Off switch.
(2)
IEC Power Socket
Connect the console to a mains power supply via the standard IEC
power socket.
3.3 XLR OUT 1-8
Outputs 1-8
Send audio to external equipment using XLR cables. Outputs 7 and 8 by default
carry the main stereo bus signals.
3.4 XLR IN 1-16
Inputs 1-16
Connect audio sources via XLR cables.
(1)
(2)
(1)
(2)