Midas HERITAGE 4000, Руководство оператора

Страница: 8 / 78

ATTENTION
The following special limitations must be observed in order to maintain safety and electromagnetic compatibility
performance.
Power Connection
Control Connections
INSTALLATION
Position
Power
The console should only be operated with the power supply connected to ground via the ground in the mains connector.
The console should only be operated with high quality screened control cables. All connector shells should be of metal
bodied construction such that the shell provides a screen when connected to the console.
All ‘DEE’ connector shells should be connected to the cable screen.
All XLR and DIN connectors should have pin one (1) connected to the cable screen.
There are a number of points to consider when installing a mixing console, many of these points will have already been
addressed even before the console is unpacked, however it is worth repeating them.
The console should be located in a convenient location commensurate with the use to which the console is being put.
Ideally a cool area is preferential not too close in proximity to electrical distribution equipment or other sources of
interference. Provision should be made for some flat surface surrounding the console to prevent it’s use as a table top.
The console’s power supply should be located as far away from the console as the connecting cable will allow. It should be
set for the voltage supply available in your area and plugged into the mains outlet using the cable provided.
!
THE POWER SUPPLY SHOULD NEVER BE OPERATED WITH
THE MAINS EARTH DISCONNECTED
Please note that the power supply contains LETHAL VOLTAGES greatly in excess of
the mains voltage and that it’s rails can produce extremely large currents which
could burn out equipment and wiring if shorted. All testing and servicing should
ONLY be carried out by a qualified engineer.
5-Pin Midas Can Bus
RS-232
Pin 1 - +18V (100mA max.)
Pin 2 - Can Low
Pin 3 - 0V Can
Pin 4 - Can High
Pin 5 - -18V (100mA max.)
Pin 2 - Receive data
Pin 3 - Transmit data
Pin 5 - GND
To ensure compatibility between the console and
interconnects, always ensure connectors and cable are of
reputable quality.
Female XLR
Male XLR
Quarter Inch Jack
Pin 1 - Screen/Ground
Pin 2 - Hot Signal
Pin 3 - Cold Signal
Pin 1 - Screen/Ground
Pin 2 - Hot Signal
Pin 3 - Cold Signal
Note: Sockets are viewed from the front face.
Sleeve - Screen/Ground
Ring - Cold Signal
Tip - Hot Signal
To ensure the correct and reliable operation or your Midas Heritage 4000 console, only high quality balanced screened
twisted pair audio cable and metal bodied connectors should be used.
Connections
1
1
2
2
3
3
PUSH
RS-232
Operators Manual
- Page 3