Midas HERITAGE 4000, Руководство оператора

Страница: 45 / 78

To recall an automute, press the automute recall switch. Any channel that is assigned to that
automute will be muted/unmuted.
If a channel is assigned to more than one automute, it’s mute will not be released until all
automute switches to which that channel are assigned are released.
The Heritage 4000 automation and assignment system uses an on-board micro card to control
the function of the console.
In fact, the H4000 has a redundant micro card should a fault occur on the other. For reliability,
changes to the console are stored to both micro cards so that the information held on each is
identical.
Beneath the ‘virtual fader recall mode’ switch on the mode switches console are two indicator
LEDs and a switch.
The two LEDs indicate which of the two micro cards are currently in operation or that there is a fault:-
Green LED - Card Active
Red LED - Card is damaged or not responding - Call an engineer as soon as possible
The switch can be used to switch between the two micro cards should one fail.
No LED - Card inactive
MUTE recall
Backup
a
u
t
o
m
u
t
e
s
1
2
3
4
5
6
7
8
9
10
a b
virtual fader
recall mode
!
This is a major function. During the transition,
there will be no control over faders and output
levels WILL change. Treat the A/B switch with
the same caution as power up/down.
The dot in the upper left hand corner of the numeric
display indicates that the scene number indicated
is the scene in current usage.
The dot in the lower right hand corner of the
numeric display indicates that the scene number
indicated hold scene data (i.e. is not empty).
act
scene
Dot Notation Dot Notation
Operators Manual
- Page 40
Automation