Microtek ArtixScan 3200XL, Руководство для начинающих

Страница: 10 / 12

10
Problems?
The green LED on the front panel indicates the status of
the scanner. The orange LED beside it stands for power
and should always stay on steady when the scanner is
on.
First, make sure that you have followed installation
steps 1 through 4. If your problem is listed here, try
the suggested solution.
1. No light comes on when the scanner is turned on.
Make sure your scanner is connected to your computer
and plugged into a power source.
2. Add/Remove Hardware Wizard appears on your
screen.
Click the “Cancel” button and close the Control Panel.
Disconnect the USB cable from the back of your computer,
and refer to the installation instructions in this guide.
3. When trying to scan, an error message appears on
your screen that reads, “Can’t Find Scanners”.
Make sure your scanner is unlocked (see Step 3).
Make sure your scanner is connected to your computer
and plugged into a power source (see Step 4).
Uninstall and reinstall the ScanWizard Pro software.
On
- Ready to scan Flashing - Scanning
Off - Call Tech Support
4. After clicking scan, a blank screen appears.
Make sure your scanner is unlocked (see Step 3).
Uninstall and reinstall the ScanWizard Pro software.
5. Having trouble scanning negatives or slides?
Make sure that you have properly inserted the templates,
as indicated in the “Using the TMA 1600-III: Positioning the
Scan Material” section of this guide. The templates should
be placed correctly on the scanner glass surface, with the
“Microtek logo” on the templates facing up.
From the Preview window of ScanWizard Pro, choose
Positive or Negative from the Scan Material menu.
Make sure that the calibration strip is unobstructed. For
location of the calibration strip, see the “Positioning the
Scan Material” section.
Uninstall and reinstall the ScanWizard Pro software.
Calibration
The Microtek Scanner ICC Profiler (MSP) program
included with your ArtixScan 3200XL is used to
calibrate your scanner to achieve consistent and
accurate color.
Two optional industry-standard IT8 color targets are
for calibration: a Reflective target to calibrate the
upper scan bed for scanning photos; and a
Transparency target to calibrate the lower scan bed
for scanning film.
You will be asked to calibrate your scanner the first
time you run ScanWizard Pro to try to scan. You
may skip calibration to proceed directly to scanning,
and then choose to come back at a later time to
perform calibration.
For more details on calibration, refer to the
“ArtixScan 3200XL User Guide” and see the
Calibration Kit section.
Reflective target
Transparency target
READY indicator (Green)
POWER indicator (Orange)