Troubleshooting 137
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX
Operator’s Manual logiJET TM4
Edition 1.2p
10.3. Incorrect Media Transport
Defect
Remedies
Incorrect media transport
(no gap detection between
labels e.g.)
- perform the basic operations
(see chapter 3)
- check if the Sync Sensor has been adjusted
correctly (see section 8.3.2)
- adjust the position of the reflective sensor
suitable to your consumables.
- check if the media has been loaded
correctly
(compare section 4.3)
- check if the ribbon has been loaded
correctly
(compare section 4.2)
- clean the the sensors
- check if the jammed consumables have
been removed completely.
No straight transport of the
consumables
(torsion or folding of the
ribbon, e.g.)
- check if the ribbon has been loaded
correctly
(compare section 4.2)
- check if the media has been loaded
correctly
(compare section 4.3)
- check if the printhead pressure was
adjusted correctly
- clean the platen roller
(see section 9.1.3)
Paper Jam
In addition to the remedies above:
- push the printhead release levers and
remove the paper (compare chapter 4)
- check if the jammed consumables have
been removed completely.
