15 of 17
All data can be subject to change without advanced notice. Version: December 6, 2018. © Micronel AG
CAUTION
Risk of burn and scalding injuries from hot surfaces of the U100HL-024KA-4!
Do not touch during operation!
NOTE
HINWEIS
Internal and external vibrations can loosen the fixation of the U100HL-024KA-4
Secure fastening against loosening. Pay attention to the permitted tightening torque.
Speed control:
The speed of the U100HL-024KA-4 can be changed during operation. This makes it possible to adjust
the working point of the U100HL-024KA-4 to a changing operating point of the plant. To do this, vary
the control voltage using Set Speed in the range of 0 to 5 VDC.
9 Cleaning Maintenance
WARNING
Risk of injury or product damage through improper handling
Please carefully read and understand the operating manual before commissioning.
Risk of injury! Before starting work on the U100HL-024KA-4:
- Disconnect from the power supply;
- Secure against restarting;
- Determine the absence of voltage;
- Vent pipes and pump (depressurization)
Before re-commissioning:
- Check that all fastening elements have been reattached and tightened;
- Check used pipelines and tanks for sufficient structural integrity;
- Check the connections of the pipe or hose connections for leak-tightness.
CAUTION
Potential risk of burn injuries from touching the hot surface of the U100HL-024KA-4!
Do not touch during operation! Allow to cool after shutting down!
NOTE
Opening the U100HL-024KA-
4 housing will void the manufacturer’s warranty!
The U100HL-024KA-4 is maintenance-free. Do not open the housing.
Overheating from insufficient passive cooling due to a dirty housing
Regularly remove dust deposits. To clean the surface with compressed air, protect the inlet
and outlet nozzles from incoming dust, otherwise particles can enter into the bearings.
Outside:
In the case of dirt or dust deposits: Clean all surfaces of the U100HL-024KA-4. Use a damp cloth for
this.
Inside:
The U100HL-024KA-4 is maintenance-free and must not be opened.
