Microcom 438TM, Руководство оператора

Страница: 220 / 231

13-14 438TM Operator’s Manual - 880049-0113
^A
^D COMMAND
X 110 General Purpose Status Byte
XX
111 Kiosk Cutter Mode: This command enables the non-volatile full and/or partial
cut operation. The ^D112 command is also used with the ^D111 command to
adjust the advance distance to the cutter blades and then retract to the home
position (dot row one).
0 Disable Kiosk Cutter Mode.
1 Enable Kiosk Cutter Mode.
4 Enable Full Kiosk Cutter Mode with LTS
XX 112 Kiosk Cutter Advance Distance Command: The valid range is from
0 to 1000 with the recommended distance of .53”.
XX 113 Verbose Mode:
0 Disable Verbose Mode.
1 Enable Verbose Mode.
114 GS1 Databar Entry Command: The GS1 Databar (formerly known as RSS-
14) barcode is fully supported by the printer. Refer to the Chapter on
Barcodes for the formatting requirements.
X 115 Set Cutter Type: Selects the type of cutter installed on the printer.
0 No cutter
1 Guillotine
2 Rotary
X 116 Synchronous Print Mode
0 Exit all sync. modes
1 Enter single sync mode
2 Enter continuous sync mode
3 Enter rapid fire continuous sync mode
4 Enter rapid fire external print mode
X 117 Cutter Hold-off: X represents the number of cuts to skip on the first X labels
following a TOF.
X
118 Home Cutter: This command will return the cutter gear to the home or open
position when issued. Only available of the X28 Series of printer’s.
XX 119 Display Memory Allocation: This command shows how all of the RAM and
flash memory is being used.
XX 120 AutoLoad Delay Selection: The AutoLoad Delay is the amount of time, in
Milliseconds, that the printer waits after detecting that media has been put into
the printer before it starts feeding it in.
^A ^D COMMAND