Microcom 438TM, Руководство оператора

Страница: 85 / 231

Chapter 5 Printer Commands
438TM Operator’s Manual - 880049-0113 5-17
0011 = Spanish
0100 = 850
0101 = German
0110 = 865
0111 = Swiss
1000 = 852
1001 = French
1010 = 863
1011 = Swedish
1100 = 437
1101 = Italian
1110 = English - UK
1111 = English – US
5.2.1.5 Software Switch #5
^AB ^D COMMAND
XX 25 Change SW5: Software Switch #5.
^AB12345678 ( each bit is represented by a numeric position number)
Position:
1 Single Button Press Error Clear: If enabled, error conditions are cleared
with a single press of the print button after reloading the printer with more
media.
If this function is disabled, pressing the print button clears the error
condition, prints the pending job, and reenters the previous halting error
state. The button must be pressed and held during printing in order to exit
the error routine. This is used to reprint the pending job until the print
realigns before continuing.
1 = Enable (Single Button Error Clear)
0 = Disable (Reprint and Align)
2 >BUTTON PRESSED< status enable.
When enabled, pressing the
button will cause the printer to report the >BUTTON PRESSED< or 0xC0
depending on the printer’s ^D21 response mode configuration. This is
typically used on systems that preload a batch of jobs to the printer but wait
on the >BUTTON PRESSED< message before sending the print
command.
1 = Enable >BUTTON PRESSED<
2 = Disabled
3 Type of Top-Of-Form Sensor:
The leading edge of the label stock can be
sensed using either a reflective sensor or a transmissive sensor. The
correct type of sensor is determined by the printer hardware configuration
being used.
1 = TOF is TRANSMISSIVE
0 = TOF is REFLECTIVE