Microcom 438TM, Руководство оператора

Страница: 86 / 231

Printer Commands Chapter 5
5-18 438TM Operator’s Manual - 880049-0113
4 Enable Power ON TOF: This bit controls whether or not the printer will
do an automatic Top of Form (TOF) when it is turned ON.
1 = Enable Power-ON TOF
0 = Disable
5
Enable Button TOF: This bit determines whether the GREEN button
functions as a Top-Of-Form or as defined by SW#2 bit 4. The button is
always configured to clear error conditions.
1 = Button is TOF
0 = Button is defined by SW#2 bit 4
6
Enable AutoLoad: This bit determines whether the AutoLoad function
is ON or OFF. When Autoload is enabled, and a no media to media
transition is detected by the printer’s internal transmissive sensor, the
printer will step the pulled the media into the printer and perform either
a TOF or a Form Feed depending on SW#5 bit 7 configuration.
1 = Enable AutoLoad
0 = Disable AutoLoad
7
Type of AutoLoad: This bit determines whether the AutoLoad function
uses the Top-Of-Form sensor (TOF), or if it uses the Form Feed
technique.
1 = Au TOF
0 = Au FF
8
Status Byte Mode: If enabled, the printer will enter a special mode that
sends a status byte to the host. See D110 command
1 = Enable Status Byte Mode
0 = Disable Status Byte Mode
5.2.1.6 Software Switch #6
^AB ^D COMMAND
XX 26 Change SW6: Software Switch #6.
^AB12345678 ( each bit is represented by a numeric position number)
Position:
1 Enable >TRAY FULL< response: This bit is used to define whether a
test pattern will print, or if the printer will halt on a >TRAY FULL< error
condition when the printer is used with the optional catch tray on the
Model 424 printer. This bit will also determine the printer’s response
when pin 4 of P17 is active.
2
Reserved
3 Enable Pre-Stock Out feature: This command supports the PSO
option and is used to detect stock out errors using an optional sensor
before the media enters the printer. Once enabled, when the PSO
(>INPUT 1<) sensor goes active the printer will finish printing the