MICRO-EPSILON Industrial Performance Unit, Руководство по эксплуатации

Страница: 16 / 24

Page 16
Operation
Industrial Performance Unit
6. Operation
6.1 Turning On
Once the supply voltage has been applied, the controller will start up automatically and enter measurement mode.
When Windows has been shut down, press the
Power
switch on the controller. The controller will start up and enter
measurement mode.
TX1
Power
2 1
RX1
TX2
RX2
The
Power
LED on the controller lights up red when a sufficient supply voltage is applied, and green during measure-
ment mode.
Measurement mode is started when the supply voltage is applied to the 3D sensor.
i
Adhere to the required warm-up times for the 3D sensors. They are required for precise measurements. You can
find details on this in the respective operating and assembly instructions.
i
If 3DInspect is not automatically visible on your monitor after start-up, you will have to change the screen settings.
To do this, press the key combination
Windows
and
P
.
6.2 System Start-Up
The controller is configured to be used as a measuring system straight away. After the supply voltage has been applied:
- The controller starts up.
- The operating system is loaded.
- The user
Operator
is logged in without having to enter a password.
- 3DInspect starts up in the mode that was used last (measurement mode) and tries to connect to the last connected
sensor.
- The measuring system can be immediately operated via the corresponding protocol (fieldbus or Industrial Ethernet)
without further user intervention if the appropriate settings have been applied.
6.3 Users and Passwords
Two users are set up for the Windows operating system. When the controller is started up, the operator is automatically
logged in (without having to enter a password), and 3DInspect is started up.
User Password
Type of Windows ac-
count
Administrator master Administrator
Operator operator Standard user
The user
Operator
has sufficient rights for setting up and operating 3DInspect.
i
Settings and parameters in 3DInspect only apply to the user who is currently logged in. Therefore, it is recommend-
ed that the user operates 3DInspect as an
Operator
.
As an operator, it is also possible to connect to the controller via a remote desktop connection.