MICRO-EPSILON 4350127.347, Руководство по эксплуатации

Страница: 53 / 68

Page 53
Installation and Initial Operation
thicknessCONTROL MTS 8202.LLT / 4350127.347
PLC =>ME
Address
Name Type Description
+0.0 Alive Signal Bit Alive Signal: Pulse with about 1 Hz.
+0.1 Enable Measure-
ment Bit 1: measurement allowed
0: no measurement allowed
+0.2 Start Single Measu-
rement Bit 1: start single measurement (triggered
with edge 0_1)
+0.3 Stop Measurement Bit 1: stop measurement (triggered with
edge 0_1)
+0.4 Reset Length Calcu-
lation Bit 0_1: length calculation reseted to zero
+0.5 Start Fix Position
Measurement Bit 1: start fix position measurement (trig-
gered with edge 0_1).
Can be stopped with bit „Stop Measu-
rement“.
+0.6 Start Pre-Calibration Bit 1: Pre-calibration of C-Frame will be
performed at parking position.
+0.7 Bit
+1.0 Bit
+1.1 Bit
+1.2 Bit
+1.3 Bit
+1.4 Bit
+1.5 Bit
+1.6 Bit
+1.7 Bit
16 Bit Reserve
+4.0 Thickness Setpoint REAL setpoint of thickness [mm]
+8.0 Thickness Upper
Tolerance REAL upper tolerance of thickness [mm]
(absolut value)
+12.0 Thickness Lower
Tolerance REAL lower tolerance of thickness [mm]
(absolut value)
+16.0 Speed of Produc-
tion REAL speed of production [m/Min]
+20.0 Length REAL length of product [m]
+24.0 RecipeID Byte[20] recipe ID - array of bytes in ASCII
code
+44.0 Position for Fix Posi-
tion Measurement REAL Position [mm] for fix position measu-
rement. Position is from home positi-
on of traversing motor.
+48.0 Edge Offset Target REAL During movement edge of target is
detected. Edge offset is added to
detected edge position.
+52.0
+56.0
+60.0
+64.0
+68.0
+72.0
+76.0
+80.0