MGL Avionics XTreme - EMS, Руководство по эксплуатации

Страница: 7 / 73

XTreme-EMS Operating Manual Page 7
3.1 EMS Display
3.1.1 Information bar
FLIGHT:
The flight time is automatically reset to zero when a new flight is started (manual or automatic flight detection). The “:” will
flash when a flight is active. The flight timer can be started in the quick select menu (Manual flight mode).
ZULU:
GMT or Zulu time display.
LOCAL:
Local time normally includes an offset from Zulu / GMT time. The time offset can be setup in the “TIMERS SETUP” menu.
TIMER:
The Timer can be configured in the quick select menu.
HOBBS:
The XTreme-EMS contains a password protected Hobbs timer. The Hobbs time can be set to the current known engine
time in the “TIMERS SETUP” menu.
MAINT (Maintenance Timer):
This timer is set in engine hours and it will count down to zero when the engine RPM is greater then the “HOBBS
MINIMUM RPM” value as set in the “TIMERS SETUP” . A good use for this function is to set the hours until your next
spark plug change or engine inspection.
The purpose of this function is to assist you in determining remaining hours until maintenance will be required. It is not
intended as a replacement for the aircraft's maintenance log. It is therefore important that the aircraft's maintenance log
be maintained in the normal manner. You should further use your own discretion in performing maintenance earlier than
indicated should any aircraft performance problems arise.