Meyer Sound RMS 4.5, Руководство пользователя

Страница: 32 / 64

28
CHAPTER 3
INSTALLATION AND SETUP
As discussed in Chapter 1, do not install your network
interface card (PCI or PCMCIA card) until after you have
completed installation of all RMS software components.
Once the software is installed, you will need to shut down
your computer and install the Network Interface Card. You
will also need to follow some additional steps to make sure
the Network Interface Card is working (covered at the end
of this section).
CAUTION: If you already have a previous
version of the RMS Software Suite running
on your computer, you must un-install all previous
components before continuing with a new instal-
lation. Click Start, Control Panel, Add/Remove
Programs, locate entries for LNS Network and RMS
application, remove the components, and restart
your computer. Contact Meyer Sound Technical
Support for assistance if needed.
Launching RMS Setup
To begin installation of the RMS software suite, ensure that
no other applications on your computer are running, then
insert the Meyer Sound RMS installation disk into your CD-
ROM drive. After a few seconds, the Setup dialog appears.
If the RMS Setup dialog fails to appear, perform the follow-
ing steps:
1. From the Windows Task Bar, click Start , then Run .
2. In the Open textbox, type the drive letter of your
CD-ROM drive, followed by “\Setup.exe.” For ex-
ample, if you CD-ROM drive is “D,” you would type
d:
\Setup.exe .
3. Click OK . The Setup dialog should appear now.
When prompted for your serial number at the User
Information dialog, locate the serial number on your RMS
installation disk and enter the number exactly as it appears,
including any hyphens. You must complete all three fields
(Name, Company, and Serial) to continue.
You will be prompted to select either a full or custom
installation.
If you choose a custom installation, you will be asked
which RMS components you would like to install. Unless
you are are networking savvy or you are reinstalling specific
components, choose to do a full installation.
At the Setup Complete dialog, un-check the
Add an RMS
Icon to the Windows startup folder
checkbox if you do
not wish to automatically run the RMS application when
you first start Windows. By default, it is left checked, and
is particularly useful if you are running an RMS-dedicated
system.