99-7431
Dash Disassembly
Nissan Altima 1998-2001
1.
Unclip the gear shifter trim bezel and remove (2)
Phillips screws exposed. (Figure A)
2.
Remove (2) Phillips screws above the radio
opening and unclip the radio trim bezel. (Figure A)
3.
Remove (4) Phillips screws from the factory radio
and disconnect the wiring.
4.
If installing a double DIN aftermarket radio:
Remove the factory brackets from the radio.
Retain the brackets for use during kit assembly.
5.
If installing a single DIN aftermarket radio:
Cut
Bracket Set #3 along the scored lines removing
the SHADED portions of the brackets. (Figure B)
6.
If installing a single DIN aftermarket radio:
Cut
and remove all mounting tabs EXCEPT tabs “B”.
(The tabs can be identified by the stamped letter
by each tab). (Figure B)
If installing a single DIN aftermarket radio,
continue to Kit Preparation.
If installing a double DIN aftermarket radio,
continue to Kit Assembly.
(Figure B)
(Figure A)
"B"
"B"
"B"
"B"
Single DIN
Only
9