Metek LAND LWIR, Руководство по установке

Страница: 5 / 48

1 - 1
LWIR Thermal Imaging Camera
Installation Guide
This guide gives you information on how to install the LWIR thermal
imaging camera and its installation accessories.
These instructions are provided as a series of simple installation diagrams,
covering the installation of the LWIR thermal camera and its mountings,
accessories and services.
The equipment must be used, maintained and serviced by properly trained
personnel, capable of following the procedures given in these instructions.
Safety may be impaired if the system is not used as indicated.
It is important to check the equipment with which you have been supplied and
then read these instructions thoroughly before proceeding with installation.
1.1 Points to note on installation
• When choosing a location to install the LWIR thermal imaging camera,
ensure that the camera has an unobstructed view of the target to be
measured.
• Try to choose a mounting location that permits easy access to the
system components wherever possible, as this will speed up any system
maintenance and repair.
• Ensure that the mounting locations chosen for the camera and its
accessories are as free as possible from vibration, dust, steam and smoke
etc.
• Ensure that the mounting locations chosen for the camera and its
accessories allow for the lengths of interconnecting cables that you have
ordered. Also, ensure that all cable runs are as secure and unobtrusive as
possible.
1.2 Using compressed air for air purging
If your application requires the use of the air purging and you intend to use
compressed air to supply air to the purge, then the following points must be
noted:
• If possible, connect the compressed air supply to the purge via a 1 m
length of 35 mm diameter smooth bore tube. This will increase the air flow
rate slightly.
• The minimum recommended air pressure is 20 psi (1.4 bar).
• The minimum recommended flow rate is 350 l/min.
• Occasional cleaning will be required to prevent the build up of everyday
dirt on site when the purge is off.
INTRODUCTION
1