MetalMaster SJM-2.5, Руководство по эксплуатации

Страница: 15 / 31

15
OPERATION MANUAL
The full-load current rating is the amperage a machine draws when running at 100% of the out-
put power. Where machines have more than one motor, the full load current is the
amperage drawn by the largest motor or a total of all the motors and electrical devices that
might operate at one time during normal operations.
Full-Load Current Rating for these machines can be found on the specification plate.
It should be noted that the full-load current is not the maximum amount of amps that the
machine will draw. If the machine is overloaded, it will draw additional amps beyond the
full-load rating and if the machine is overloaded for a long period of time, damage, overheating,
or fire may be caused to the motor and circuitry.
This is especially true if connected to an undersized circuit or a long extension lead. To reduce
the risk of these hazards, avoid overloading the machine during operation and make
sure it is connected to a power supply circuit that meets the requirements.
3.5 FULL-LOAD CURRENT RATING
3.6 TEST RUN
Once assembly is complete, test run the machine to ensure it is properly connected to the
power and safety components are functioning correctly. Check that the direction of the rolls
is correct by depressing each pedal on the roving foot pedals and make sure that the rolls are
rotating in the correct direction.
If the direction is incorrect, isolate the machine and have the electrician make changes to the
wiring.
Testing The Emergency Stop Button
Make sure that the emergency button has been reset.
Start the machine and then press the emergency stop button. The machine should stop and
the power should be cut off. If the machine cannot be started then th emergency stop is
working correctly. To reset the emergency stop twist the red top until it pops up.
If you find an unusual problem during the test run, immediately stop the machine, disconnect
it from power, and fix the problem BEFORE operating the machine again. The Troubleshooting
table in the Maintenance section of this manual may be able to help. If the problem persists the
contact your dealers service technician.