Metabo W 10-125, Инструкция по эксплуатации, Страница: 16 / 120

Connect to mains supply
With VTC / TC electronic system (depending on
equipment):
The red electronic system indicator (6) lights up
briefly when the mains connection is made, thus
indicating standby mode.
8 Operation, Switching On/Off
Always guide the machine with both
hands!
First switch on, then apply the tool to
the work piece!
It must be avoided that the machine
draws in additional dust and shavings.
When switching the machine on and off,
keep it away from dust deposits.
After switching off the machine, only
place it down when the motor has come
to a standstill.
In the case of VTC / TC electronic control:
the red electronic signal indicator (6) comes on
briefly when the machine is switched on.
Machines with slide-switch (1):
(Machines with the designation W... or WE...)
Switching on: slide the slide-switch (1) forward
until it engages.
Switching off: press the rear end of the slide-
switch.
Machines with switch lock:
(Machines with the designation W… …-150 … or
WE …-150 …)
Switching on: press the rear of the slide
switch (1), then slide forward until it engages.
Switching off: press the rear of the slide switch.
Machines with switch lock
(Safety switch because it cannot be locked):
(Machines with the designation WEP...)
Do not carry or suspend the machine
by the trigger switch (9).
Switching on: slide the switch lock (8) in the
direction of the arrow and press the switch
trigger (9).
Switching off: Release the switch trigger (9).
Tools with switch trigger (9):
(Machines with the designation WP... or WPS...)
Switching on: slide the switch lock (8) in the
direction of the arrow and press the switch
trigger (9).
Switching off: Release the switch trigger (9).
Continuous operation:
(Machines with the designation WP...)
Switch on the angle grinder and slide the switch
lock (8) forward until it engages.
Switching off continuous operation:
Briefly press the switch trigger (9) and release.
If switched on continuously, the
machine continues running if it is
jerked out of your hands. Therefore,
always hold the machine with both
hands on the handles, stand safely, and
concentrate on your work.
Restart safety device
(only with VTC / TC electronic system):
If the mains connection is made with the angle
grinder still switched on or if the power supply is
restored after an interruption, the angle grinder
will refuse to start. The red electronic system
indicator (6) flashes. Switch angle grinder off and
then on again.
9 8
1
0
I
W... ...-150 ...
WE ...-150 ...
1
0
I
W ...
WE ...
16
ENGLISH
02 ENG_Paddle_8390_0207 08.11.2007 15:40 Uhr Seite 16