Docking Station Set Up Manual 83529-9800 Rev A
Page 7
2.3.
Power Up
The Docking Station must be plugged in to work. A power supply is not included with
the docking station. The Docking Station is powered by the same 8.4V 1.3A power
supply shipped with the Met One Instrument, Inc. handheld device it will be used with.
This power supply must be used to provide the correct power to the unit. Do not
attempt to connect any other charger or adapter to this device. Doing so may result in
equipment damage.
3.
Connecting a Device
The Docking Station is designed to charge the battery of select Met One Instruments,
Inc. handheld devices. The front of the device must face forward. An alignment pin is
positioned on the contact plate. This pin fits into a hole at the base of the handheld unit.
This is used to prevent damage to the docking station or handheld unit by stopping a
device from being placed on the docking station backwards.
Each device will fit securely onto the Docking Station when encased in its rubber boot.
If the rubber boot is not used, an 83584 bootless adapter is placed in the base of the
docking station to hold the device.
Figure 3 - Docking Station with device without rubber boot (left) and showing bootless
adapter in Docking Station (right)
