Merlin prolift 230T, Руководство по установке

Страница: 2 / 16

E
D
R4 117
9 G2.16 10/03
2
Important safety instructions for
installation
To prevent fire or shock hazard, do not expose the opener to rain or moisture.
To avoid electrical shock do not open the cabinet without disconnecting the opener from the mains.
WARNING Incorrect installation can lead to severe injury. Follow all installation in-
structions.
Garage doors are under great spring tension. Do not attempt to adjust spring tension. Do not
loosen any brackets under spring tension. Do not remove springs from the door. Merlin does not
accept responsibility for damage or injury resulting from installing this opener. Unless you have
appropriate training, refer door adjustments to the door manufacturer.
To avoid difficulty during installation, do not connect the opener to the mains or run the door opener
until instructed to do so.
Do not use force sensitivity adjustments to compensate for a binding or sticking garage door.
Excessive force may damage the garage door.
Before installing the drive remove all unnecessary ropes or chains and disable any equipment, such
as locks, that is not needed for powered operation.
Before installing the drive check that the door is in good mechanical condition and that it is cor-
rectly balanced. Check that it opens and closes properly.
Install the actuating member for the manual release (red handle on a rope) such that it rests at a
height of less than 1.8 m.
Install any fixed control, wired or wireless, within sight of the door but away from moving parts and
at a height of more than 1.5 m.
Install the drive such that all moving parts (except the door and the manual release) are at a height
of more than 1.8 m.
Permanently attach the label warning against entrapment in a prominent place, or near any fixed
control.
Permanently fix the label concerning the manual release adjacent to its actuating member (thread
the cord through the holes in the manual release warning card).
After installation, ensure that the mechanism is properly adjusted and that the drive reverses when
the door contacts a 40mm (50mm for UK) high object placed on the floor.
The appliance is not intended for use by young children or infirm persons without supervision.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
CE compliance after installation (EC countries only)
It is the responsibility of the installer of the opener to ensure that the forces measured at the
leading edge of the door are within the guidelines of BSEN 60335-2-95:2001. This may require
adjustment of the drive and may also require adjustment of the door. Specialised measurement
equipment may be required. Contact Merlin for assistance if necessary. If the measured forces
exceed the guidelines then Merlin M102 non-contact sensors must be fitted.