Merlin prolift 230T, Руководство по установке

Страница: 10 / 16

E
D
R4 117
9 G2.16 10/03
10
Setting the door travel
limits
NOTE Repeated operation of the opener in a short
period of time during setup may trigger the ther-
mal cutout of the motor. In this case you will have
to wait for approximately five minutes for the mo-
tor to cool sufficiently to continue the installation
process. If the unit has overheated you will hear
the relays clicking in response to the transmitter
or pushbutton but the motor will not operate. After
cooling down, normal operation is able to resume.
The limit adjustment screws are inside the lamp cover and
are marked as up limit and down limit. One full turn of either
screw results in around 250mm of trolley travel.
STEP 1: Plug the opener into an earthed three-pin 220-240V outlet and switch on the power.
The opener’s courtesy lamp may turn on, or may flash for five seconds.
STEP 2: Remove the lamp cover by turning the catch on its underside. Remove the green control
panel cover to expose the setup controls. Observe
the red and green indicator LEDs. The red LED will
stay on continuously at the fully closed position. The
green LED will stay on continuously at the fully open
position. Identify the green operate button.
Ensure the door is engaged on the trolley.
STEP 3: Press and hold the green operate button
to move the door up and down into the required
fully open or fully closed positions. Each time the
operate button is pressed the door will stop or move
in the opposite direction.
STEP 4: When the door is at the fully closed posi-
tion, turn the down-limit screw (located adjacent to
the courtesy lamp) until the red close-LED stays
on continuously.
STEP 5: When the door is at the fully open posi-
tion, turn the up-limit screw (located adjacent to
the courtesy lamp) until the green up-LED stays
on continuously.
STEP 6: If the door can not be moved sufficiently
far then look at the red and green LEDs. If one of
these is on continuously then the door has stopped
at a limit point. Adjust that limit to allow more travel.
One turn of a limit adjustment screw results in
250mm of door travel.
exit delay
Light door
roller: L
tall door
auto-
close
on
on
R
on
short
long
open
auto
open
force
operate
learn delete
close
auto
close
force
program
remove
for setup
manual
control
Door travel
limit adjustments