MerCruiser Sterndrive 350 MAG MPI, Руководство пользователя

Страница: 81 / 148

Section 5 - Maintenance
90-864195061 NOVEMBER 2006 Page 73
Tube Ref No. Description Where Used Part No.
114
Power Trim and Steering Fluid Power steering system 92-858074K01
3. Reinstall the fill cap/dipstick.
Changing
Power steering fluid does not require changing unless it becomes contaminated with water
or debris. Contact your authorized Mercury MerCruiser dealer.
Engine Coolant
Checking
!
WARNING
Allow the engine to cool down before removing the coolant pressure cap. A sudden loss
of pressure could cause hot coolant to boil and discharge violently. After the engine has
cooled, turn the cap 1/4 turn to allow any pressure to escape slowly, then push down and
turn the cap all the way off.
1. Remove the cap from the heat exchanger and observe the fluid level.
a
6101
a - Heat exchanger cap
2. The coolant level in the heat exchanger should be at the bottom of the filler neck. If the
coolant level is low, contact your authorized Mercury MerCruiser dealer.
3. Install the cap onto the heat exchanger.
IMPORTANT: When reinstalling the pressure cap, be sure to tighten it until it seats on the
filler neck.
4. With the engine at normal operating temperature, check the coolant level in the coolant
recovery bottle.