MerCruiser 3.0L TKS Alpha, Руководство пользователя

Страница: 55 / 92

Section 5 - Maintenance
90-8M0053263 NOVEMBER 2010 Page 47
2. The coolant level in the thermostat housing should be at the bottom of the filler neck. If the coolant level is low, contact your
authorized Mercury MerCruiser dealer.
3. Install the cap onto the thermostat housing.
IMPORTANT: When reinstalling the pressure cap, be sure to tighten it until it seats on the filler neck.
4. With the engine at normal operating temperature, check the coolant level in the coolant recovery bottle.
5. The coolant level should be between the "ADD" and "FULL" marks.
6102
6. Add the specified fluid as necessary.
Tube Ref No. Description Where Used Part No.
122
Extended Life Antifreeze/
Coolant
Closed Cooling System 92-877770K1
Filling
NOTICE
Using propylene glycol antifreeze in the closed cooling system can damage the cooling system or the engine. Fill the closed
cooling system with an ethylene glycol antifreeze solution suitable to the lowest temperature to which the engine will be exposed.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
NOTICE
Air trapped in the closed cooling system can cause the engine to overheat, resulting in engine damage. Minimize the possibility
of trapping air when initially filling the closed cooling system by positioning the boat so that the front of the engine is higher than
the rear of the engine.
NOTE: Add coolant only when engine is at normal operating temperature.
1. Remove the fill cap from the coolant recovery bottle.
2. Fill to the "FULL" line with the specified coolant.
Tube Ref No. Description Where Used Part No.
122
Extended Life Antifreeze/
Coolant
Closed Cooling System 92-877770K1
3. Install the fill cap onto the coolant recovery bottle.
Changing
Contact your authorized Mercury MerCruiser dealer.