MerCruiser 3.0L TKS Alpha, Руководство пользователя

Страница: 81 / 92

Section 6 - Storage
90-8M0053263 NOVEMBER 2010 Page 73
Tube Ref No. Description Where Used Part No.
19
Perfect Seal Aft heat exchanger plug 92-34227Q02
8. Prior to launching the boat or starting the engine, install the drain plugs, reconnect the hoses, and tighten all hose clamps
securely.
9. If the boat was drained in the water, open the seacock (if equipped) or unplug and reconnect the water inlet hose prior to
operating the engine.
Clearing Clogged Blue Drain Hoses
!
CAUTION
Disconnecting the blue drain hoses can cause serious burns due to hot water. Check all hose connections before operating the
engine and never disconnect the hoses until the engine has had suffient time to cool.
1. If the engine can be started proceed to Step 2. If the engine cannot be started, proceed to Step 8.
2. If one hose is flowing freely, reconnect it to the bracket.
3. Ensure the clogged blue drain hose is in the correct position below its connection point on the block.
4. Turn on the bilge pump and supply water to the water inlets. If the boat is out of the water, install the flushing attachment and
open the water source fully to provide maximum water flow.
a - Flushing attachment
Flushing Device 91‑44357Q 2
9192
Attaches to the water intakes; provides a fresh water connection when flushing
the cooling system or operating the engine.
5. Start the engine and allow it to operate at idle until the obstruction is cleared from the hose or for approximately 1 minute,
whichever occurs first.
6. Check for water draining from the blue drain hose. If after 1 minute of idling, the blue drain hose is still clogged, proceed to
Step 7. If water is draining, shut off the engine and continue with Step 3 of
Single Point Drain System
.
7. Shut off the engine. Disconnect the water source if connected to a flush device.
a
7358