MerCruiser 3.0L TKS Alpha, Руководство пользователя

Страница: 53 / 92

Section 5 - Maintenance
90-8M0053263 NOVEMBER 2010 Page 45
Engine Oil Drain Pump
1. Loosen the oil filter to vent the system.
2. Remove the dipstick.
3. Install the oil pump onto the dipstick tube.
a - Typical oil pump
b - Dipstick tube
c - Oil drain hose
4. Insert the hose end of the crankcase oil pump onto an appropriate container and, using the handle, pump until the crankcase
is empty.
5. Remove the pump.
6. Install the dipstick.
Changing Filter
1. Remove and discard oil filter.
2. Coat sealing ring on new filter with engine oil and install.
3. Tighten oil filter securely (following filter manufacturer's instructions). Do not overtighten.
4. Remove oil fill cap.
IMPORTANT: Always use dipstick to determine exactly how much oil is required.
5. Add recommended engine oil to bring level up to the bottom of the OK range on the dipstick.
6. With the boat at rest in the water, check the oil level and add specified fluid to bring the oil level up to, but not over, the full or
OK range.
NOTE: Adding 0.95 liters (1 quart) of engine oil will raise the level from the add mark to the top of the OK range.
Engine Model Capacity Fluid Type
3.0L (181)
3.8 liters
( 4 U.S. Quart)
Mercury/Quicksilver Synthetic Blend MerCruiser Engine Oil 25W‑40
7. Start the engine, run the engine for three minutes, and check for leaks. Stop the engine. Allow approximately 5 minutes for
the oil to drain into the oil pan. The boat must be at rest in the water.
Power Steering Fluid
Checking
1. Stop the engine and center the sterndrive unit.
2. Remove the fill cap/dipstick and observe the level.
a. Proper fluid level with engine at normal operating temperature should be within the warm range.
mc70571-1
a
c
b