Mercedes-Benz E-class, Руководство оператора

Страница: 337 / 446

#
To mount: position hub cap 1 and turn
until it is completely flush with the wheel.
#
Position socket 2 on hub cap 1 .
#
Position wheel wrench 3 on socket 2 and
tighten the hub cap clockwise.
Specified tightening torque: 18 lb-ft
(25 Nm).
#
Raise the vehicle (
→
page 335).
Raising the vehicle when changing a wheel
Requirements
R
There are no persons in the vehicle.
R
The vehicle is prepared for a wheel change
(
→
page 334).
R
The hub caps have been removed
(
→
page 334).
Important notes on using the jack:
R
Only use the vehicle-specific jack that has
been tested and approved by Mercedes-Benz
to raise the vehicle.
R
The jack is only designed for raising and
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
R
The jack must be placed on a firm, flat and
non-slip surface. If necessary, use a large,
load-bearing, non-slip underlay.
R
The base of the jack must be positioned ver‐
tically under the jack support point.
Rules of conduct when the vehicle is raised:
R
Never place your hands or feet under the
vehicle.
R
Do not lie under the vehicle.
R
Do not start the engine and do not release
the parking brake.
R
Do not open or close any doors or the trunk
lid.
#
Using the wheel wrench, loosen the wheel
bolts on the wheel you wish to change by
about one full turn. Do not unscrew the bolts
completely.
Wheels and tires 335