Mercedes-Benz E 180, Руководство пользователя

Страница: 402 / 492

The fuses in your vehicle serve to disconnect
faulty circuits. If a fuse blows, all the compo-
nents on the circuit and their functions will
fail.
Blown fuses must be replaced with fuses of
the same rating, which you can recognise by
the colour and fuse rating. The fuse ratings
are listed in the fuse allocation chart.
If the newly inserted fuse also blows, have the
cause traced and rectified at a qualified spe-
cialist workshop, e.g. a Mercedes-Benz
Service Centre.
Before replacing a fuse
Observe the important safety notes
(
Y
page 399)
X
Secure the vehicle against rolling away
(
Y
page 199).
X
Switch off all electrical consumers.
X
Turn the key to position 0 in the ignition
lock and remove it (
Y
page 177).
or
X On vehicles with KEYLESS-GO, make sure
the ignition is switched off (
Y
page 177).
All indicator lamps in the instrument cluster
must be off.
The fuses are located in various fuse boxes:
R
Fuse box in the engine compartment on the
left-hand side of the vehicle, when viewed
in the direction of travel
R
Fuse box in the boot/luggage compart-
ment on the right-hand side of the vehicle,
when viewed in the direction of travel
The fuse allocation chart is located in the
vehicle tool kit in the stowage compartment
under the boot/luggage compartment floor
(
Y
page 383).
Fuse box in the engine compartment
Observe the important safety notes
(
Y
page 399)
G
WARNING
When the bonnet is open, and the windscreen
wipers are set in motion, you can be injured
by the wiper linkage. There is a risk of injury.
Always switch off the windscreen wipers and
the ignition before opening the bonnet.
! Make sure that no moisture can enter the
fuse box when the cover is open.
! When closing the cover, make sure that it
is lying correctly on the fuse box. Moisture
seeping in or dirt could otherwise impair
the operation of the fuses.
X
Make sure that the windscreen wipers are
switched off.
X
Open the bonnet.
X Remove any existing moisture from the
fuse box using a dry cloth.
X
To open: take lines
;
out of the guides.
X
Move lines
;
to one side. Route the lines
behind connection
=
to do this.
X
Open retaining clamps
:
.
X
Remove the fuse box cover forwards.
X
To close: check whether the rubber seal is
seated correctly in the cover.
X
Insert the cover at the rear of the fuse box
into the retainer.
X
Fold down cover and close clamps
:
.
X
Secure lines
;
in the guides.
X
Close the bonnet.
400
Electrical fuses
Breakdown assistance