MEP SHARK 282, Руководство по эксплуатации и обслуживанию

Страница: 50 / 152

MEP S.p.A.
5--14 42
Use and maintenance manual SHARK 282
"
Swing the head from left to right until it is positioned at the required angle, as
indicated by the graduated scale on the turntable.
Always rotate the head when it is in the upper position to avoid blade collision
with the moving jaw on the clamp.
"
Relock the turntable lock/release lever.
"
Make the cut in the required operating mode, following the preliminary
safety instructions set out in this chapter.
Angled cuts 60
°
to the left
"
Undo the bush on the 45
°
left reference stop, as illustrated in the figure
below, using a 36 mm wrench;
"
Slacken the turntable lock/release lever;
Attention