MEP SHARK 282, Руководство по эксплуатации и обслуживанию

Страница: 22 / 152

MEP S.p.A.
3--4 14
Use and maintenance manual SHARK 282
The operator must not perform any risky operations or operations not
required for the machining operation under way (e.g. remove swarf or
metal shavings from the machine while cutting).
Remove equipment, tools or any other objects from the cutting zone;
always keep the working area as clean as possible.
Before starting any cutting operations, ensure that the workpiece is
securely held in the vice and the machine has been set correctly. A
number of examples of how to clamp different profiles correctly in our
machines are shown below.
Do not use the machine to cut pieces that exceed the capacity of the
machine as listed in the machine specifications.
Never move the machine while it is cutting.
Do not use blades of different sizes to those recommended in the
machine specifications.
When cutting very short pieces, make sure that they are not dragged
behind the support shoulder, where they could jam in the blade.
When using the pneumatic vice (MA version) check that the jaws move
right up to and effectively clamp the workpiece, as the maximum travel is
only 8 mm, and check that the clamping procedure is correct.
When working on the band saw, wear gloves only when handling
materials and for tool changing or adjustment operations. Only perform
one operation at a time and do not hold more than one item or operate
more than one device simultaneously. Keep hands as clean as possible.
Warning: if the blade jams in the cut, press the emergency stop
push---button immediately. If this does not free the blade, slowly loosen
the vice, remove the piece and check the blade or blade teeth for
breakage. Replace the blade if necessary.