21
DE
EN
10.5 Installation tasks in the case of repairs
The tasks described below may only be car-
ried out by a qualified electrician.
10.5.1 Fitting sockets
Fit the flanged socket into the front panel and fasten it
with four screws.
Connect the supply leads to the relevant residual current
circuit breaker or the socket and check for tight fit.
10.5.2 Fitting the device carrier
Fitting the device carrier
Fit the device carrier (
1
) into the enclosure.
All the while, carefully pulling out the supply line at the
rear of the device.
Once the device carrier is completely seated in the enclo-
sure, fasten the strain relief for the supply line.
1
Securing the device carrier
The enclosure has a total of twelve screws that need to be
fitted (socket side, underside, sides).
Screw the screws (
1
) into the enclosure and thus secure
the device carrier located inside.
Use a suitable tool.
Check all conductor connections and pre-wired compo-
nents in the power distribution box for firm seat.
Tighten loose threaded connections.