Mendota MEDALLION, Инструкция по установке и эксплуатации, Страница: 22 / 36

LOG INSTALLATION
The burner is attached to a metal air plenum (See drawing below). The Burner/Air Plenum Assembly is designed to
be placed in the stove firebox as a one piece unit. The log module for the Stove is a one piece unit for ease of
installation and maximum flame ambiance.
1. Pull open magnetic hinged side door panels located on each side of stove.
Turn the four latches counterclockwise and slide glass door towards you, and off stove. Set aside.
2. Place additional coals on Log Grate horizontal bar - against front burner. Edge of coals should be against, but
not covering front burner flame holes.
3. Place approximately 20 coals between burner tubes on right side of pilot.
4. Carefully unpack one piece log assembly and center on log rest, between Side Log Tabs. Place log assembly
over front locating pins.
5. Place glowing embers (wool) sparsely on top coals, in front of front log. Additional wool may be rubbed on
front surfaces of log for additional glow. Add wool to "burned out" space between front logs. Fill area to back
burner.
Note: Do not block holes with excessive wool, or delayed ignition and sooting can occur.
6. With glass removed, light pilot, and check for smooth ignition. Reinstall door, and check for smooth ignition. If
any delay occurs, make sure that no coals or wool is blocking pilot from front or rear burner holes.
7. Reinstall door, and check for smooth ignition. If any delay occurs, make sure that no coals or wool is blocking
pilot from front or rear burner holes.
NOTE: DO NOT PAINT BURNER - BURNER PORT AREA IS INTENTIONALLY LEFT UNPAINTED.
2
1