Mendota FV44i-0616, Инструкция по установке и эксплуатации

Страница: 29 / 58

ORIFICE
WASHERS
(2)
3/8" COMP X 1/8 NPT
BRASS FITTING
FRONT
ORIFICE
INSIDE HERE
PILOT LIGHT
HOOD
REAR
ORIFICE
INSIDE HERE
MOTORIZED
PRESSURE
REGULATOR
5. Remove both Rear and Front Burners. Locate and Identify the Rear Burner
Orifice Spud and the Front Burner
Orifice Spud. Both Front and Rear Orifice Spuds are removed and installed using a ½” deep well socket and ratchet.
6. Install Rear Burner Orifice #65-14-00054(#54 drill) for the Rear Burner. Tighten down securely.
7. Install Front Burner Orifice #65-14-00055 (#55 drill) for the Front Burner. Tighten down securely.
8.
Locate Pilot Light
in the middle
of firebox. While holding the pilot base body with large vice grips tightly, loosen Pilot
Light’s hex shape base using a ½” open end wrench. Rotate counter clock-wise ¼ turn to loosen.
9. Pilot arrives from the factory set for NG. Push NG/LP Adjustment Clip inward all the way to set it for LP. See detail
view, below. If you see “NAT” printing on the Adjustment Clip, this indicates that the pilot is set to burn NG. Push Clip
in so that “NAT” is not visible.
10. Tighten down Hex shaped base of pilot using a ½” open end wrench.
WARNING:
DO NOT PROCEED WITH OPERATION OF THIS FIREPLACE UNLESS BURNER "CYCLES" ON/OFF WITHOUT DELAYS!
C
hecking Burner(s) Ignition Characteristics
Once the conversion to LPG and all the above steps have been completed, light the main burners.
Use Remote Transmitter to turn on Pilot Light and burners. Main burner should now light IMMEDIATELY and flame
should not "lift" off burner. If there is any delay in ignition or if flame is "lifting off" burner, turn off burner and carefully
check for proper installation of logs/coals, vent system and proper pilot flame impingement on burner. Logs or coals must
not block pilot flame or main burner flame. Vent system must be leak proof.
Attaching LPG
C
onversion Labels
Two printed informational labels are included with the LPG Conversion Kit. Attach these two labels to the back surface
of the Serial Number Plate that is located in the convection air cavity
on the side
the firebox. If you are de-rating this
appliance at a high altitude, also attach the High Altitude De-Rating Label, supplied in the Owner’s Manual Packet, to
this same surface.
Prior to attaching the labels, fill in all the information that is requested in these labels.
PAGE 25