Mendota FV44i-0616, Инструкция по установке и эксплуатации

Страница: 20 / 58

12. Remove the Vent Adapter by unlatching spring loaded
lever from front of the unit
13. Tightly secure 3” and 4” flex vents with clamps
provided. Seal vent cap/flashing to top of chimney with
weatherproof sealer. Seal areas between flex pipes
and existing chimney, at damper area, with unfaced
fiberglass insulation.
14. Carefully slide Insert into the fireplace opening (Note:
Plug in the AC Power cord to a 110 volt AC receptacle
inside the fireplace opening or extend it out and
connect to a grounded wall outlet.
15. Slide Vent Adapter forward between guide rails. Vent
Adapter’s front flat section should contact insert top as
you slide the Vent Adapter forward.
16. Use Spring loaded lever to pull Vent Adapter back into
place on the unit and then latch it to front of unit.
17. You are now ready to hook up the Insert to gas supply.
Be sure gas plumbing instructions and all state and
local codes have been carefully followed. Be sure all
items on Installation Check-Off List have been
completed.
NOTE: AGA APPROVED FLEX LINES ARE APPROVED FOR USE WITH MENDOTA INSERTS.
18. Carefully slide the Insert into place in the fireplace opening. At this time, check that Insert is level and plumb with the fireplace
opening and positioned in the middle of the opening. If Insert is unsteady or needs leveling, the unit may need to be “shimmed
with washers under the bottom corners of insert.
19. The proper Insert Faceplate can now be placed in position. Assemble surround by following instructions supplied with
faceplate kit. Select the appropriate size of faceplate to cover the area between the Insert and existing fireplace opening.
IMPORTANT
INSTALLATION, SERVICING AND REPAIR MUST BE DONE BY A QUALIFIED SERVICE PERSON. THE INSERT SHOULD BE
INSPECTED AT LEAST ANNUALLY BY A PROFESSIONAL SERVICE PERSON. MORE FREQUENT CLEANING MAY BE
REQUIRED DUE TO EXCESSIVE LINT DEPOSITS FROM CARPETING, BEDDING MATERIAL, ETC. IT IS IMPERATIVE THAT THE
CONTROL COMPARTMENT BURNERS AND CIRCULATING AIR PASSAGEWAYS OF THE INSERT BE KEPT CLEAN.
3x3 VENT
ADAPTER
20"-24"
Existing
Fireplace Liner
Approved Flue Liner
Approved Flue Liner
Sheet Metal
Strap Loop
Rope
Weight
Rope
PAGE 16