RedHandScope60MHz
Handheld DSO & DMM
4-Input Connections
7
include: Voltage Unit Scale of Channel 1 (CH1 VOL); Voltage Unit Scale of Channel 2 (CH2
VOL); Primary Time base (TIME BASE), zero point position of channel 1(CH1 ZERO), zero
point position of channel 2(CH2 ZERO), trigger horizontal position (TIME) and trigger level
position (TRIG).
When performing Waveform Calculation, the users can also adjust and calculate the Display
Multiplying Factor of waveform (CHM VOL) and the vertical display position (CHM ZERO).
In cursor measurement mode, the users can adjust the positions of Cursor 1 (V1 or T1) and
Cursor 2 (V2 or T2).
12.
OSC
▼
: Oscilloscope display downward adjustment key.
13.
OSC
▲
: Oscilloscope display upward adjustment key.
14.
OSC/DMM: Operation mode switching key between oscilloscope and multimeter.
15.
AUTO SET:
Under the Multimeter Mode, when performing the current or voltage measurement, you can
make a measurement switch between AC and DC with this key pressed; when performing the
resistance measurement, you can select resistance, diode, On/Off or capacitance measurement
circularly with this key.
While this key is used for auto setting under the oscilloscope operation mode.
16.
RUN/STOP: key for running or stopping the operation.
17.
MENU
▼
: Choose the lower item on the menu list.
18.
MENU: Show / Hide the menu
19.
MENU
▲
: Choose the upper item on the menu list.
20.
F1
～
F5: Switch or Adjust options for each menu.
5. Using the Scope
5.1 About this Chapter
This chapter provides a step-by-step introduction to the scope functions. The introduction does not
cover all of the capabilities of the scope functions but gives basic examples to show how to use the
menus and perform basic operations.
5.2 Power-Up the Oscilloscope
Connect oscilloscope to AC power via a power adapter as shown in Figure 1. (The oscilloscope
