RedHandScope60MHz
Handheld DSO & DMM
5-Using the Scope
15
at the bottom of the screen.
3.
Press
F1
key to select the factory settings. The oscilloscope is set to be the factory settings.
Refer to figure 11
figure 11: Reset the Oscilloscope
5.7 Input Connections
Refer t figure 2.
Look at the bottom and the right of the Oscilloscope. The Oscilloscope has seven signal inputs:
two safety BNC jack inputs (CH1 and CH2) for scope measurements, three safety 4-mm banana
jack inputs for Multimeter R, V and A measurements, and two quadratic jack inputs for
Multimeter capacitance measurements.
Isolated input allows independent floating measurements between Multimeters and Scopes.
5.8 Displaying an Unknown Signal with Auto Set
The Auto-Set feature lets the Oscilloscope display and measure unknown signals automatically.
This function optimizes the position, range, time base, triggering and assures a stable display of
virtually any waveform. . This feature is especially useful for quickly checking several signals.
To enable the Auto-Set feature, do the following:
1.
Connect the test probe to the tested signals.
2.
Press the
AUTO SET
key and the Oscilloscope is under the automatic measurement
condition. The tested signals appear on the screen.
