B. ALARM FEATURES PROGRAMMING:
ALARM FEATURE “
I
” PRORAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch
2
times and holding in on
2
nd
push until
one
chirp with a long chirp is hearing then
release the valet switch. You are now in the Alarm feature
‘I’
programming mode.
3. Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to change.
a.
The siren chirps and LED pause will indicate newly setting.
b.
The system would advance to [2] LED flash, [2] chirp. (The factory default settings is always [1] LED
flash, [1] chirp.)
4 Depress the transmitter button ‘A’ again to change the feature again. Simple keep re-depressing the
transmitter button ‘A’ again until the module advances to your desired setting.
5. Depress the transmitter button ‘B’ corresponding to the feature ‘B’ you wants to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
All chirps on
Siren chirp on only
Horn chirp on only
All chirps off
2
Active arming
Passive arming
without passive door
locking
Passive arming with
passive door
locking.
3
Automatic Rearm on
Automatic Rearm off
4
Instantly Door Ajar
Warning
45 seconds delay
Door Ajar Warning.
5
+
Without Car-jack mode
Active Car-jack mode
Passive Car-jack
mode
Exit:
Turn Ignition to 'ON' position, or leave it for 15 seconds. A 3 long chirps & 3 parking light flashes to
confirm exit.
3 / 45 seconds Delay Door Ajar Warning:
This feature controls the error chirp that is generated if the system is armed with the door trigger active. This
useful in a vehicle that has a long dome light delays after the door has been closed. If the system is armed
before the dome light has turned off, the security system will generate the door trigger error chirp. Use this
feature to disable the door open error chirp.
ALARM FEATURE “
II
” PRORAMMING:
1 . Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2 . Push the Valet switch
4
times and holding in on the
4
th
push until
two
chirps with a long chirp is hearing
then release the valet switch. You are now in the Alarm feature
‘II’
programming mode.
3 . Press and release the transmitter button ‘A’ corresponding to the feature ‘A’ you want to program.
Press
T
ransmitte
r
Button
One Chirp / LED
one pulse
Factory Default
Setting
Two Chirps / LED
two pulse
Three Chirps / LED
three pulse
Four Chirps / LED
four pulse
1
0.8-second Door
lock pulses.
3.5-second Door
lock pulse.
Double pulse unlock
Door lock with
“Comfort Feature”
2
Ignition controlled
door locks &
unlocks
Ignition controlled
door locks only
Ignition controlled
door unlocks only
Without ignition
controlled door locks
& unlocks
3
Door lock before
start
Door lock after
shut-down
Door lock before
start and Door lock
after shut-down
Without this feature
4
Pathway illumination
feature “off”
Parking light “on” for
30- second upon an
unlock signal
Parking light “on” for
30- second upon an
unlock signal &
10-second upon a
lock signal.
5
+
Disable the out of
range check.
Enable the out of
range check
6
+
Override Without
Password Pin Code
Override With
Password Pin Code
11
