Medora SolarBee SB10000DM, Руководство пользователя

Страница: 24 / 55

23
Maintenance and Field Adjustment
Distributor Dish Level Setting
The SolarBee distribuitor dish depth in the
water is a key factor in maintaining the near-
laminar flow of water coming off the machine.
The distributor dish level setting is measured
from the top lip of the dish up to the water
surface. For this SB10000DM , the depth level
should fall on or between this range:
2.0 inches to 2.5 inches (5.1cm to 6.4cm)
Distribution Dish Level Adjustment
TOOLS RECOMMENDED:
Tape Measure or Ruler
STEP 1: If SolarBee is not on, turn the On/Off
switch to the On position.
STEP 2: Observe if the dish level is too deep or
not deep enough at the three locations where
each float arm extends out from the machine.
This can be done using a tape measure or
locating the notch on each chain bracket for
machines having a hose. If using the notch on
each chain bracket, the water level should be
even with the notch (see picture).
STEP 3: Set the dish to the correct level in each
of the three locations. To raise the dish level,
rotate the turnbuckle around (clockwise) so that
it is expanding. To lower the dish level, rotate
the turnbuckle around (counter-clockwise) so
that it is compressing.
STEP 4: Double check dish level at all three
locations and fine tune as necessary.
Distance Between Distributor Dish And Water Level
Water Level Even With Notch On Chain Bracket
Turnbuckle Handle
Chain Bracket
Notch
Dish Depths For Different
Models of SolarBees
SB10000
SB5000
SB2500
WATER LEVEL NOTCH
SETTING FOR:
2-in to 2.5- in (5.1-cm to 6.4-cm)
Dish Level
Water Level