P3V Veterinary Digital Ultrasonic Diagnostic Imaging System User Manual
- 25
-
4.3.6. Printer Installation
This system supports video printers and USB printers.
To install a video printer:
1.
Power off the main unit and the printer.
2.
Connect the VIDEO IN (video input) of the video printer with the VIDEO OUT (video
output) of the main unit.
3.
Connect the REMOTE of the video printer with the REMOTE of the main unit.
Reference Figure 4-7 I/O Ports on the Left Panel
4.
Power on the main unit and run the printer.
NOTE:
The video printers are used in patient vicinity.
To install an USB printer:
1.
Power off the main unit and the printer.
2.
Connect the printer with the main unit by using a USB cable.
3.
Power on the main unit and run the printer.
If the printer can not work normally, check the printer presetting, see Section
5.7.3, General
Presetting
.
NOTE:
1. Multiple portable socket-outlet is not intended for the device, anybody, who connects it
to the signal input or output connector to configure a medical system, must make sure
that it complies with the requirements of the valid version of the system standard
IEC/EN 60601-1-1. If in doubt, consult our technical service department or your local
distributor.
2. If you want to use a multiple portable socket-outlet to supply power to the whole P3V
system, you are suggested to calculate the system power consumption when building
a P3V system so as to match the system power consumption with the power
sustained by a multiple portable socket-outlet.