Technical Manual
Motion Detector/Automatic Switch 55/63
Series .02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49-2263-4588 • [email protected] • www.mdt.de
22
22
4.3.4 Output objects
Light channel
HVAC channel
Three different objects are possible for the output object.
The following table shows possible settings (here: switch, light channel):
Figure 8: Settings
–
Output objects
The following parameters are relevant for the output objects:
ETS-Text
Dynamic range
[Default value]
Comment
Object type for output
–
Light / HVAC
•
switch
•
dimming absolute
•
scene
Selection of the object type that is sent
when a motion is detected.
Output 2 (Additional
switch object)
•
not active
•
ON and OFF
Activation of an additional switching
object.
Only available for light channels!
Table 10: Settings
–
Output object
Output 2 (Additional switch object)
In addition, a separate switching object can be activated - regardless of the object type. This is always
a 1-bit object.
If, for example, a dimming value is sent as output object 1, a 1-bit telegram can also be sent via
output 2 to control a status LED or similar.
Important:
This object is only available for the light channels!
Object type for output
The parameter defines the data point type of the output object.
These are explained below:
