Technical Manual
Motion Detector/Automatic Switch 55/63
Series .02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49-2263-4588 • [email protected] • www.mdt.de
19
19
Active sensors
The active sensors can be set for each channel. This allows the detection range of the channel to be
limited. For example, if only one area in a corridor is to be detected, only one sensor can be activated.
The alignment of the sensors can be recognised by activating the parameter "Information about
sensor assignment".
Fully automatic
If the presence detector is set as fully automatic, every detected presence causes the output to
switch on and is switched off again after the follow-up time has elapsed.
Half automatic (manual switching)
In half-automatic mode, the output is switched on via the object "External push-button short" and
automatically switched off again after the follow-up time has elapsed.
Monitoring time slot
The monitoring time slot is available for the HVAC. This causes a longer detection to be required for
switching on. To switch on the channel, at least one detection must have taken place in each of the
set monitoring time slots.
The length of the monitoring time slot determines how long the system waits for a detection within a
time slot.
The
follow-up time
describes the time that elapses after the last detection of a movement until the
output is switched off. The follow-up time can be set differently for Day/Night. For example, with a
follow-up time of 3 minutes, the light would be switched on for at least 3 minutes if movement was
detected. Each new detection leads to a retriggering and thus a restart of the follow-up time.
