Technical Manual
Motion Detector/Automatic Switch 55/63
Series .02
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49-2263-4588 • [email protected] • www.mdt.de
54
54
4.9 Temperature
Temperature measurement only available with SCN-BWM55T.G2!
The following picture shows the available settings:
Figure 35: Settings
–
Temperature
The following table shows the possible settings:
ETS-Text
Dynamic range
[Default value]
Comment
Temperature
measurement
•
not active
•
active
Activation of the temperature
measurement.
Send measured value
on change of
not active
0,1
–
1 K
[0,2 K]
Minimum rate of change for the current
measured value to be sent.
Send measured value
cyclically
not active
1 min
–
120 min
Defining a fixed period after which the
current brightness measurement value
is sent repeatedly.
Correction value for
sensor
-
80 … 50 x0,1 K
(0)
Setting the value by which the
temperature is corrected.
Table 48: Settings
–
Temperature
With temperature measurement, the temperature in the room can be measured and sent to the bus.
The temperature can be sent to the bus both at an adjustable change and cyclically (at fixed time
intervals).
The measured temperature can be shifted up or down via the "Correction value for sensor"
parameter. For example, a correction value of "50" corresponds to a correction of 5 K.
The following table shows the available communication object:
Number
Name/Object Function
Length
Usage
130
Temperature
–
Measured value
2 Byte
Sending the current temperature value
Table 49: Communication object
–
Temperature
