ANI Monitor V1 - Continouous analgesia monitoring system
MD/PRD/IN16.ANIV1 V.10 – 29 SEP 2021
41
7.11
Shutting down the ANI Monitor V1
Pressing the button
[
Kapat]
(figure 34) ends the session and will shut down the ANI
Monitor V1.
NOTE: it is possible to shut down the monitor by pressing directly the switch located on
bottom right hand corner of the front side (see figure 12) only if the context prevent you to
reach the main menu (figure 34). This is however not recommended because it could affect
the monitor’s proper functioning.
8
Troubleshooting
Problems
Diagnoses
No ECG displayed on the monitor.
Check the connection wire from the
acquisition device to the monitor. Try to
unplug and plug again the acquisition device
from the monitor.
An ECG signal is detected but seems to be
incoherent (flat, irregular, interfered…)
Check the electrodes are well stuck on the
skin. Check also the electrodes position (see
chapter 4.2)
ECG waves seem physiologically incorrect
Check that electrodes are well placed along
an imaginary line through the heart.
The Mdoloris Medical Systems software
does not start when the monitor is booted.
Reboot the monitor thanks to the switch on
the front side. If the problem continues,
please contact your Mdoloris Medical
Systems representative.
The ANI Monitor V1 shuts down by itself
without reason.
Check the power supply wire is connected to
the monitor and reboot the monitor like
explained in this user’s manual (chapter 5).