MDG eMINI, Руководство пользователя

Страница: 21 / 28

eMINI fogger
User Guide, Rev: A/a, April 2020 21 / 28
TROUBLESHOOTING
Contact MDG, if symptoms are not listed, or if the provided solutions fail to resolve the issue.
Table 2: Symptoms and Solutions
Symptoms Probable Causes and Suggested Actions
The fogger does not switch on
•
Verify that AC power cord is properly connected
on both ends.
•
Check the fuse or the breakers of your VAC
entry. The wattage of the fogger is around 1415
W.
•
Verify the AC voltage on the power cord.
90~250 VAC.
The fogger does not produce fog
•
Verify that the Unit is ON
«UNIT

ON»
•
Verify that the UNIT is READY
«STATE = READY»
The fogger needs approximately seven to eight
(7 to 8) minutes to be ready. While the heating
module is heating, the % HEAT must vary, in
State menu.
•
Verify that the Unit is not in a FAIL state
«STATE = FAIL»
If Yes, check the symptoms below
•
Verify the communication mode.
«Mode»
You cannot control the fogger locally if you are
in DMX mode, and vice-versa.
•
If you are in DMX mode:
•
Verify the cable
•
verify the DMX address and the channels
•
Verify the Universe parameters and the DMX
Start Address
… ∕…