MDG eMINI, Руководство пользователя

Страница: 17 / 28

eMINI fogger
User Guide, Rev: A/a, April 2020 17 / 28
DMX C
ONTROL
The MDG eMINI can be controlled via a DMX512-A USITT standard protocol.
WARNING
Activating the «DMX» mode («INTERFACE 
MODE

DMX
») , controls the MDG eMINI
only by DMX signal. If the DMX wire is unplugged or DMX signal is lost , the fogger
initiates an automatic shutdown procedure .
Activating the
«AUTO» mode («INTERFACE 
MODE

AUTO
») , controls MDG eMINI
by DMX, only if there is a signal. If the DMX wire is
unplugged
or DMX
signal is lost
, the
fogger
keeps the last DMX values
.
WARNING
In « AUTO Mode » , DMX commands always take precedence over Local commands.
The MDG
eMINI
provides a simple way to check if there is DMX signal:
The user can change the DMX Start Address in the Interface Menu («
DMX Add
»), and choose any value
between 1 and 510 (512, last DMX channel).
The user can change the DMX Start Address in the Interface Menu («
DMX Add
»), and choose any value
between 1 and 511 (512, last DMX channel).
The fogger uses three (3) DMX channels, but has two different personalities:
•
Channel 1
0 (0%)

UNIT OFF

128 (50%)

UNIT ON

255 (100%)
•
Channel 2 0 (0%) to 255 (100%) , FOG OUTPUT (from minimum to maximum)
OR 0 (0.1 s)
to
255 (25.5 s)
, BURST DURATION
•
Channel 3 0 (0%)

FOG OFF

1 28 (50%)

FOG ON

255 (100%)
These channels have the same behaviour that the menus of the local interface (see Operating instructions
paragraph).
No DMX Signal
DMX Signal