MCZ EGO-STAR Hydromatic 12, Руководство по установке

Страница: 38 / 52

38
21-SAFETY DEVICES AND ALARMS
WRITTEN ON THE
DISPLAY
TYPE OF PROBLEM SOLUTION
A22
Brazier not closed
Possible obstruction in the brazier. Clean.
If the problem persists, contact a service centre.
A23
Room probe failure
Possible fault in the safety component. Contact an
authorised service centre to have the component
checked and, if needed, replace the component.
Exiting the alarm conditions
NEVER open the stove door whilst it is either in the initial start-up or on its shut down cycle, pellets will still be
smoldering or therefore volatiles may be present.
ATTENTION!
If during operation or initial ignition you encounter combustion smoke spillage in to the room from the appliance
or the flue then please switch off the appliance, ventilate the room and contact the installation / service technician
immediately.
When the stove enters an alarm state, an automatic cooling/shut-off phase begins, at the end of which the cause of the alarm is displayed
on the small panel.
Before resetting the alarm, follow the controls indicated in the previous table, and then press the RESET key for a few seconds (or remove
power to the stove using the main ON/OFF switch on the back of the stove).
If the indicated actions do not solve the problem, the alarm condition will occur once again with different timing based on the alarm type:
in this case, contact technical assistance.