McLaughlin MCL 36C, Руководство по ремонту

Страница: 86 / 90

REPAIR INSTRUCTIONS
McL 36/42C
5.6.3
ASSEMBLY
Step 4: Clutch Assembly
Refer to the following steps for clutch assembly:
Steps 29-31 Disk Kit Assembly
Steps 23-32 Seal Kit Assembly
Steps 20-32 Bearing Kit Assembly
20. Install bearing removal plugs in the cylinder and piston
face. Apply a light coat of “Locktite” removable thread
locker #242 (or equivalent) to the inner and outer races of
the bearings. (NOTE: APPLY A FEW DROPS OF REMOV
ABLE THREAD SEALANT TO THE PLUGS. TIGHTEN
PLUGS TO “JUST BELOW” THE CYLINDER AND PISTON
FACES).
21. Press a new sealed bearing onto the pressure plate by
pressing on the outer race of the bearing.
22. Press a new sealed bearing onto the pressure plate by
pressing on the inner race of the bearing.
23. Apply a light oil to all o-ring surfaces and grooves before
assembling the clutch. Install o-rings into the proper o-ring
grooves.
24. Align the anti-rotation pin in the piston with the blind holes
in the cylidner. Carefully press the piston onto the cylinder.
As the piston o-ring begins to slide onto the cylinder, it may
be necessary to guide the o-ring into the o-ring groove.
25. Assemble the pressure plate and bearing assembly into
the cylinder and piston assembly by pressing on the
pressure plate.
26. Assemble the hub into the cylinder assembly by support-
ing hub on the splined end. Place the cylinder assembly
on the hub and press the bearing onto the hub. (NOTE:
PRESS ON THE INNER RACE OF THE BEARING). As the
bearing is being pressed onto the hub, it is necessary to
align the internal spline of the pressure plate with the
external spline of the hub.
23
24